Skip to content
In this section
FIELD GUIDE

Check aim with Motion Test

Applicable modelsBTC-4E40BTC-6DCLNBTC-8E-HP5UBTC-PSMHDS-E

Walk through the target area and watch the indicator.

  1. Enable Motion Test in the setup menu.
  2. Walk across the intended capture area. The front red indicator flashes when you are detected.
  3. Adjust height and aim until the route is covered.
  4. Turn Motion Test off before leaving the camera to record.

Model-specific instructions: BTC-4E40BTC-6DCLNBTC-8E-HP5UBTC-PSMHDS-E.